Crown Victoria V8-4.6L Flex Fuel (2008)
Accelerator Pedal: Service and Repair
Accelerator Pedal
ACCELERATOR PEDAL
Removal and Installation
1. NOTE: To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal sensor
electrical connectors.
Disconnect the accelerator pedal sensor electrical connector.
2. Remove the 2 bolts and the accelerator pedal assembly.
-
To install, tighten to 9 Nm (80 lb-in).
3. To install, reverse the removal procedure.
