Crown Victoria V8-4.6L Flex Fuel (2008)
-
When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be ignited by hot
vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.
1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire
Suppression System. Failure to follow the instructions may result in serious personal injury.
With the vehicle in NEUTRAL, position it on a hoist.
2. Release the fuel system pressure.
3. NOTE: Some residual fuel may remain in the fuel tubes and fuel filter after releasing the fuel system pressure. Upon disconnecting or removing
any fuel-related component, carefully drain residual fuel into a suitable container.
Disconnect the fuel tube-to-fuel rail spring lock coupling.
4. Disconnect the fuel vapor test port tube-to-fuel vapor tube quick connect coupling.
5. Disconnect the fuel tube-to-fuel filter inlet and outlet spring lock couplings.
6. Disconnect the fuel vapor tube-to-fuel vapor tube assembly quick connect coupling.
7. Disconnect the fuel tube-to-fuel pump (FP) module spring lock coupling.
8. Remove the 9 fuel tube bundle bolts.
-
To install, tighten to 12 Nm (9 lb-ft).
9. Remove the fuel tubes (liquid and vapor) from the vehicle.
10. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
