Crown Victoria V8-4.6L Flex Fuel (2008)
6. NOTE: It is not necessary to remove the A/C compressor stud bolts.
Loosen the 3 A/C compressor stud bolts enough to slide the compressor down one inch, allowing access for CKP sensor removal.
-
To install, tighten to 25 Nm (18 lb-ft).
7. Remove the CKP sensor bolt.
-
To install, tighten to 10 Nm (89 lb-in).
8. Remove the CKP sensor.
9. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.