Crown Victoria V8-4.6L Flex Fuel (2008)
All vehicles
9. Disconnect the pretensioner electrical connector.
10. Remove the bolt and safety belt retractor and pretensioner assembly.
Installation
All vehicles
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
1. Position the safety belt retractor and pretensioner.
2. Install the bolt.
-
Tighten to 40 Nm (30 lb-ft).
3. Connect the electrical connector.
Vehicles with seat side air bags
4. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE: The side impact sensor bolts must be installed in the sequence shown.
Install the side impact sensor with bracket.
1
Position the side impact sensor with bracket.
2
Install the bolt.
-
Tighten to 12 Nm (9 lb-ft).
3
Install the bolt.
-
Tighten to 12 Nm (9 lb-ft).
4
Connect the electrical connector.
All vehicles
5. Install the secondary safety belt guide screw.
6. Install the upper and lower B-pillar trim panels.
7. Install the safety belt anchor and bolt.
-
Tighten to 40 Nm (30 lb-ft).
8. Install the safety belt anchor bolt cover.
