Crown Victoria V8-4.6L Flex Fuel (2008)
reset process.
NOTE:
-
For best results, the OCS system should be at or near room temperature, 10°C to 29°C (50°F to 85°F).
-
If the first attempt to carry out the OCS system reset is unsuccessful, a second attempt must be made.
Carry out the OCS system reset active command using the scan tool.
-
With the front passenger seat empty, use a scan tool to trigger the active command.
21. NOTE: The ignition switch must be cycled after the OCS system reset.
Cycle the ignition switch from ON to OFF.
22. Prove out the SRS as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately 6 seconds and then turn off. If an air bag SRS fault is present,
the air bag indicator will:
-
fail to light.
-
remain lit continuously.
-
flash.
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the RCM to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault exists, a chime will sound in a
pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered must be diagnosed and repaired.
Clear all continuous DTCs from the RCM using a scan tool.
23. NOTE: When installing a new OCS, a prepaid return postcard is provided with the new OCS. The serial number for the new part and the vehicle
identification number (VIN) must be recorded and sent to Ford Motor Company.
Fill out the necessary information on the OCS traceability card and return it along with the complete inoperative occupant classification sensor to
Ford Motor Company.
-
When returning the inoperative OCS include: seat cushion foam pad, bladder, electronic control unit, pressure sensor (transducer), hose,
electrical connectors and wire harness (service part OCS only).
