Crown Victoria V8-4.6L Flex Fuel (2008)
Alignment: Service and Repair
Ride Height Adjustments
Ride Height Adjustments
WARNING: Vent all air pressure from the air suspension system prior to disconnecting or removing any air suspension components. It is
dangerous to remove air suspension components while under pressure. Failure to follow this instruction may result in serious personal
injury.
CAUTION: The suspension height D dimensions are for reference only. The vehicle attitude must be controlled by the correct dimensions to
prevent vehicle damage.
NOTE: Improper air suspension ride height D dimension can be caused by an air suspension system that is incorrectly set.
1. Position the vehicle on a level surface over an open repair pit.
2. Open the luggage compartment and verify that the air suspension switch is in the ON position.
3. Turn the ignition switch to the RUN position and wait at least 2 minutes.
4. Position the special tool on the rear axle.
5. Measure the ride height D dimension.
1. Release the set screw.
2. Pull the sliding post and scale up until it touches the bottom of the inboard frame rail and lock the set screw.
3. Measure the ride height D dimension.
