Crown Victoria V8-4.6L Flex Fuel (2008)
^
To install, tighten to 18 Nm (13 lb-ft).
3. Remove the pressure line bracket-to-engine nut.
^
To install, tighten to 7 Nm (62 lb-inch).
4. Disconnect the power steering pressure switch electrical connector.
5. Disconnect the pressure line-to-pump fitting.
^
Discard the Teflon(R) seal.
^
To install, tighten to 65 Nm (48 lb-ft).
6. NOTE: When connecting a fitting with a Teflon(R) seal, a new seal must be installed.
To install, reverse the removal procedure.
^
Using the special tool, install a new Teflon(R) seal on the pressure line-to-pump fitting.
^
Fill the power steering system.
7. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.