Crown Victoria V8-4.6L Flex Fuel (2008)
4. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the nut and detach the outer tie rod from the wheel knuckle.
^
To install, tighten to 80 Nm (59 lb-ft).
5. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove and discard the stabilizer bar link upper nut.
^
To install, tighten to 63 Nm (46 lb-ft).
6. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the stabilizer link lower nut and the stabilizer bar link.
^
Discard the nut.
^
To install, tighten to 55 Nm (41 lb-ft).
7. Detach the wheel speed sensor wiring harness retainer from the steering knuckle.
8. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove and discard the upper ball joint nut.
^
To install, tighten to 150 Nm (111 lb-ft).
9. NOTE: Use the holding feature to prevent the stud from turning while removing the nut.
Remove the lower ball joint nut and then remove the wheel knuckle.
^
Discard the nut.
^
To install, tighten to 150 Nm (111 lb-ft).
10. If necessary, remove the 4 bolts and the wheel bearing and wheel hub.
^
To install, tighten to 120 Nm (89 lb-ft).
11. To install, reverse the removal procedure.
12. Check and, if necessary, align the front end.
13. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
