Crown Victoria V8-4.6L Flex Fuel (2008)
14. From the passenger compartment, remove the selector lever cable from the vehicle.
Installation
1. From inside the vehicle, feed the selector lever cable through the opening in the bulkhead and downward toward the transmission.
2. Seat the selector lever cable rubber grommet in the bulkhead opening.
3. Route the shifter end of the selector lever cable to the floor console mounted selector lever.
4. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the cable end is
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the cable end is correctly installed.
Install the selector lever cable housing retainer to the selector lever mechanism and connect the cable to the selector lever.
5. Secure the selector lever cable to the instrument panel wiring harness.
6. Place the selector lever in the (D) position.
7. Install the bulb and the selector lever bezel.
