Crown Victoria V8-4.6L Flex Fuel (2008)
snapped onto the ball stud. Press the selector lever cable into the bracket and listen for the cable to click in place. Pull back on the selector lever
cable to make sure that it is locked into the bracket. Also make sure that the selector lever cable end is correctly installed onto the ball stud. Pull
back on the selector lever cable end to make sure that the cable end is correctly installed.
Connect the selector lever cable to the selector lever cable bracket. Do not connect the selector lever cable to the manual control lever at this time.
1. Install the new selector lever cable retainer.
2. Connect the selector lever cable to the selector lever cable bracket.
13. Clip the selector lever cable to the clips that route the cable upward toward the top of the engine compartment.
14. Adjust the selector lever cable.
15. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and
procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.
If equipped with fire suppression system, repower the system.
16. After completing all adjustments, and with the vehicle on the ground, turn on the electrical power to the air suspension, if so equipped.
