Crown Victoria V8-4.6L Flex Fuel (2008)
Brake Shift Interlock Actuator - Floor Shift (Part 2)
Removal and Installation
1. WARNING: Always deplete the backup power supply before repairing or installing any new front or side air bag supplemental restraint
system (SRS) component and before servicing, removing, installing, adjusting or striking components near the front or side impact
sensors or the restraints control module (RCM). Nearby components include doors, instrument panel, console, door latches, strikers, seats
and hood latches.
Refer to the Description and Operation portion of Air Bag Systems for location of the RCM and impact sensor(s).
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least 1 minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
Failure to follow these instructions may result in serious personal injury or death in the event of an accidental deployment.
Disconnect the battery ground cable. Wait at least one minute before proceeding with the procedure to allow the backup power supply to deplete
its energy.
2. Remove the instrument panel finish panel and disconnect the electrical connector.
3. Lift the console finish panel up and remove the finish panel.
4. Push the shift handle bezel down and disconnect the transmission control (TC) switch harness.
