Crown Victoria V8-4.6L Flex Fuel (2008)
Part 2
Special Tool(s)
Special Tool(s)
Removal and Installation
1. Remove the rear door trim panel.
2. Position the watershields aside.
3. Remove the 3 rivets and position the rear door latch remote control aside.
4. Remove the inner belt line moulding.
5. Remove the nut and outer belt line moulding.
-
To install, tighten to 12 Nm (9 lb-ft).
6. Remove the rear door glass top run inner bolt.
-
To install, tighten to 10 Nm (89 lb-in).
7. Connect the window control switch electrical connectors.
8. Lower the rear door window glass to gain access to the rivets.
9. CAUTION: Do not attempt to forcibly remove the rivets as damage to the rear door window glass may result. Prior to removing the rivet