Crown Victoria V8-4.6L Flex Fuel (2008)
Part 2
Removal and Installation
1. Remove the cowl panel grille.
2. Remove the 2 nuts and position the evaporative emission canister purge valve aside.
-
To install, tighten to 6 Nm (53 lb-in).
3. Remove the 6 bolts and position the wiper mounting arm and pivot shaft aside.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Disconnect the 2 harness pushpins and the windshield wiper motor electrical connector.
5. Disconnect the windshield washer hose and remove the wiper mounting arm and pivot shaft.
6. Remove the wiper motor assembly.
7. To install, reverse the removal procedure.
