Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Rear Door Window Regulator: Service and Repair
Removal
1. If rear door window glass is in the down position and is inoperable, the following steps must be taken; if rear door window glass is operational,
proceed to Step 2.
a. Remove rear door trim panel and watershield. See:
CAUTION:
Be careful not to drill through the mechanism behind inner door panel.
CAUTION:
Be careful not to strike or scratch rear door window glass.
b. Mark inner door panel and drill three holes 12.7mm (0.5 inch) as shown.
c. Remove rear door electric window regulator retaining screws through holes.
CAUTION:
Be careful not to strike or scratch rear door window glass.
d. Remove rear door electric window regulator off mounting bracket through access hole.
e. Remove window regulator electric drive from drum housing and cover.
f. Raise rear door window glass to full-up position by hand and secure with a clamp.
g. Proceed to Step 4.
CAUTION:
When servicing rear door electric window regulator assembly, regulator cable tension must not be altered. Cable tension is preset at production.
Improper adjustment may result in premature rear door electric window regulator failure or erratic operation.
2. Remove rear door trim panel and watershield.
3. Remove rear door window glass.
4. Disconnect window regulator electric drive wiring connector.
5. Remove three 6.35mm (1/4-inch) rivets retaining motor bracket to inner panel and two 6.35mm (1/4-inch) rivets retaining lower bracket of rear
