Crown Victoria V8-4.6L SOHC VIN 6 (1996)
3.
Remove and replace the two (2) rear springs that support the "Flex-o-lator" with revised springs (blue in color). Refer to Figure 1.
4.
Position the mesh on top of the "Flex-o-lator" grid so that it will be positioned between the foam cushion pad and "Flex-o-lator" wires.
5.
Install the new foam pad and discard the old pad.
6.
Install the seat cushion trim and reinstall the seat back to the seat cushion following the procedure outlined in Section 01-10 of the appropriate year
Crown Victoria Service Manual.
7.
Install the seat assembly into the vehicle. Be sure to torque the seat track-to-floor bolts to the specification listed in the appropriate year Crown
Victoria Service Manual, Section 01-10.
PART NUMBER
PART NAME
F7AZ-5460001-AA
Seat Cushion Kit - Bucket Seat -
1995 Vehicles
F7AZ-5460001-BA
Seat Cushion Kit - Bench Seat - 1995
Vehicles
F7AZ-54632A23-BA
Pad Assembly - LH - Bucket Seat -
1996-97 Vehicles
F7AZ-54632A23-AA
Pad Assembly - LH - Bench Seat -
1996-97 Vehicles
OTHER APPLICABLE ARTICLES: NONE
