Crown Victoria V8-4.6L SOHC VIN 6 (1996)
ROUTING CLIP INSTALLATION
1.
Turn off air suspension, if equipped, and raise the vehicle.
2.
Remove front brake line routing clip. Refer to Figure 1.
3.
Remove intermediate brake line routing clip. Refer to Figure 1.
4.
Inspect for brake line wear. See Figure 1.
5.
If rubber on brake line is worn through to the point that steel is showing, the brake line must be replaced. Go to Page 5 for Brake Line
Replacement instructions.
NOTE:
Position all lines into each routing clip.
