Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Braking Sensor/Switch: Service and Repair
1. Disconnect battery ground cable, then the wiring harness lead at switch connector.
2. Using screwdriver, pry connector locator from holes in brake pedal support.
3. Unsnap switch hook from pin on Anti-Lock Brake System (ABS) adapter bracket.
Fig. 160 Pedal Travel Switch Replacement
4. Hold brake pedal down to gain access, then, using needle nose pliers, squeeze ears on switch mounting clip. Push clip through hole in dump valve
adapter bracket.
5. Remove rear attaching screw on ABS adapter bracket, then loosen second screw.
6. Rotate bracket, then remove switch and wire assembly.
7. Reverse procedure to install.
8. Rotate switch and ensure mounting clip ears are completely engaged.
9. Adjust switch.
