Crown Victoria V8-4.6L SOHC VIN 6 (1996)
2. From below vehicle, remove sensor wire from routing bracket located on top of rear axle carrier housing.
3. Remove attaching screw from clip, holding sensor wire and brake tube bracket on axle.
4. Remove sensor to rear adapter retaining bolt, then remove sensor.
5. Reverse procedure to install, ensuring that split ring is located in groove properly. Opening in ring should not line up with notch in tube shaped
sensor retainer.
Fig. 122 Rear Speed Sensor Installation
5. Install sensor into bracket with notch correctly aligned with bracket. Push sensor until split ring locks sensor into place.
6. Torque retaining bolt to 40-60 in lb.
7. Torque sensor and brake tube to bracket retaining screw to 40-60 in lb.
