Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Cruise Control Servo: Service and Repair
1. Remove retaining clip from actuator cable adjuster fitting.
2. Push actuator tube out of adjuster fitting attached to throttle cable.
3. Disconnect harness connector at servo, then remove two servo assembly to vehicle attaching nuts.
4. Remove actuator cable cap from servo by depressing cap locking arm and rotating cap counterclockwise.
5. Remove cable ball slug from servo pulley by pushing slug from out of pulley slot.
6. Reverse procedure to install. Torque assembly attaching nuts to 45-61 in lb.
