Crown Victoria V8-4.6L SOHC VIN 6 (1996)
21. Disconnect 42-pin connector and transmission harness connector and position out of the way.
22. Disconnect crankshaft position sensor, air conditioning compressor clutch and canister purge solenoid connectors.
23. Raise vehicle on a hoist.
NOTE: The front lower bolt on the power steering pump will not come all the way out.
24. Remove bolts retaining power steering pump to engine block and cylinder front cover.
25. Wire the power steering pump out of the way.
26. Remove four bolts retaining oil pan to front cover.
27. Remove crankshaft damper retaining bolt and washer from crankshaft.
28. Install Crankshaft Damper Remover T58P-6316-D on damper and pull damper from crankshaft.
29. Position drain pan under oil filter and remove oil filter.
30. Disconnect EVO sensor and oil sending unit.
31. Remove oil filter and position EVO sensor and oil pressure sending unit harness out of the way.
32. Lower vehicle.
33. Remove nine bolts and two stud bolts retaining RH camshaft cover to cylinder head and remove camshaft cover.
