Crown Victoria V8-4.6L SOHC VIN 6 (1996)
22.
Clip throttle/speed control cables on routing bracket.
23.
Clip fuel charge wiring harness to fuel supply manifold, then connect right side fuel injectors, Engine Coolant Temperature (ECT) sender and
EGR Vacuum Regulator (EVR) solenoid.
24.
Install PCV valve and hose.
25.
If equipped with ignition wires, connect the ignition wires to spark plugs and routing clips. If equipped with a coil-on-plug system, install and
connect individual coils to each cylinder.
26.
Install air cleaner outlet tube.
27.
Connect battery negative cable, then remove memory saver.
28.
Fill cooling system as follows:
^
Fill coolant recovery reservoir with 50/50 mixture of antifreeze and water until the mixture flows out of the disconnected heater hose.
^
Connect heater hose to right rear corner of intake manifold.
^
Fill coolant recovery reservoir to below the filler neck seat.
^
Place heater temperature selector in Maximum heat position.
^
Install pressure relief cap.
^
Start and run engine until normal operating temperature (thermostat opens) is reached.
^
Stop engine and allow to cool.
^
Refill reservoir to the COLD FULL LEVEL.
29.
Check engine for fuel and cooling system leaks.
