Crown Victoria V8-4.6L SOHC VIN 6 (1996)
4.
With an assistant's help, install intake manifold assembly. Tighten screws in sequence shown in Figure 9, to 20-30 Nm (15-22 lb/ft). Hand tighten
bolt No. 7 prior to final tightening.
5.
Clip fuel charge wiring harness to studs on left side valve cover.
6.
Connect Idle Air Control (IAC) motor electrical connector.
7.
Connect Throttle Position (TP) sensor electrical connector.
8.
Attach two (2) wiring harnesses to clip on left rear of intake manifold.
9.
Connect fuel lines to spring clips.
10.
Connect fuel charge wiring harness to left side fuel injectors, Engine Coolant Temperature (ECT) sensor and retaining stud.
11.
Connect throttle and speed control cables to throttle body.
12.
Connect radiator hose to thermostat housing.
13.
Install alternator. Tighten bolts to 20-30 Nm (15-22 lb/ft).
14.
Position alternator upper support bracket close to installed position, then connect all alternator electrical connectors.
15.
Install alternator upper support bracket. Tighten bolts to 8-12 Nm (71-106 lb/in).
16.
Attach alternator wiring harness to intake manifold.
17.
Install drivebelt on alternator.
18.
Connect main engine wiring harness pushpin to rear of intake manifold.
19.
Connect two (2) vacuum lines to top of throttle body adapter.
20.
Connect vacuum line to EVAP solenoid.
21.
Connect EGR tube to EGR valve. Tighten nut to 35-45 Nm (26-33 lb/ft).
