Crown Victoria V8-4.6L SOHC VIN 6 (1996)
11. From passenger side of dash panel, fold carpeting back on the RH side of the floor. Remove the bottom LH screw of the two screws that support
the A/C recirculating air duct.
12. From the engine side of the dash panel, remove the three nuts (one upper and two lower) from the three evaporator assembly mounting studs. Also
remove the two screws (one drill point and one sheet metal) from the blower motor and blower motor wheel assembly portion of the case A/C
evaporator core housing.
13. Pull the bottom of the A/C evaporator core housing assembly away from the dash panel to disengage the two bottom studs. Move the top of the A /
C evaporator core housing assembly away from the dash panel disengaging it from the top stud and maneuver the case up and over the wheel well
splash panel.
A/C Evaporator Core
NOTE: If an A/C evaporator core leak is suspected, the A / C evaporator core must be leak-tested before it is removed from the vehicle.
NOTE: Whenever the A/C evaporator core is replaced, it will be necessary to replace the suction accumulator / drier.
