Crown Victoria V8-4.6L SOHC VIN 6 (1996)
-
Rerun self test.
Is DTC B1342 still present?
YES
REPLACE lighting control module. RESTORE vehicle. RETEST system.
NO
System operating normally.
B1352 - Ignition Key-In Circuit Failure
DTC B1352: Ignition Key-In Circuit Failure
B1352-1 - Perform Lighting Control Module Self Test
-
Make sure all doors are fully closed to second latch.
-
During self test, make sure than no new warnings are displayed on instrument cluster. Rerun self test.
Is DTC B1352 still present?
YES
GO to B1352-2.
NO
System operating normally.
B1352-2 - Check Lighting Control Module Function
-
Enter Diagnostic Data Link.
-
Enter LCM - Lighting Control Module.
-
Enter PID/DATA Monitor and Record.
-
Make sure ignition key is in ignition switch.
-
Select PID IGN_KEY - Ignition Key.
Does PID read IN?
YES
REPLACE lighting control module. RESTORE vehicle. RETEST system.
NO
LEAVE ignition key in the ignition switch. GO to B1352-3.
B1352-3 - Check Circuit 158 (BK/PK) For Open
-
Disconnect lighting control module connector C1.
-
Using an ohmmeter connected to a known good ground, connect second lead to pin C1-3, circuit 158 (BK/PK).
-
Measure resistance.
Is resistance 5 ohms or less?
YES
REPLACE lighting control module. RESTORE vehicle. RETEST system.
NO
GO to B1352-4.
B1352-4 - Check Ignition Key Warning Switch Function
-
Disconnect ignition key warning switch.
-
Measure resistance of Circuit 158 (BK/PK) from lighting control module connector pin C1-3 to circuit 158 (BK/PK) at ignition key warning
switch connector.
Is resistance 5 ohms or less?
YES
REPLACE ignition key warning switch. RESTORE vehicle. RETEST system.
NO
SERVICE Circuit 158 (BK/PK) for open circuit. RESTORE vehicle. RETEST system.
B1462 - Seat Belt Switch Circuit Failure
DTC B1462: Seat Belt Switch Circuit Failure
B1462-1 - Perform Lighting Control Module Self Test
-
Make sure all doors are fully closed to second latch.
-
During self test make sure that no new warnings are displayed on instrument cluster.
-
Rerun self test.
Is DTC B1462 still present?