Crown Victoria V8-4.6L SOHC VIN 6 (1996)
5. Perform On-Demand Self-Test on the selected module. Use diagnostic procedure outlined under New Generation Star Tester Operation,
On-Demand Self-Test.
NOTE: The Self-Test program for an individual module may produce observable outputs.
6. Record all On-Demand Self-Test DTCs and go to MODULE DTC INDEX Table to continue diagnosis. If On-Demand Self-Test passed and
concern(s) still remains, then go to Step 7.
7. Use the continuous DTCs recorded in Step 4 and go to MODULE DTC INDEX Table to continue diagnosis. If no continuous DTCs retrieved in
Step 4, then concern(s) is not related to Multiplex Communication Network. Return to referred section for non-network related problem(s).
Wiggle Test
The wiggle test is designed to help identify and locate intermittent failures in the vehicle wiring harness and system components. Upon entering wiggle
test, several inputs and outputs of the module are monitored for change of state. When a state change is encountered, an audible tone can be heard and/or
a diagnostic trouble code (DTC) will be displayed on the New Generation Star (NGS) tester 007-00500. For modules which store DTCs, the DTC
description will determine an open circuit, short to ground or a short to B+. By initiating wiggle test and pulling on different areas of the vehicle harness,
intermittent open and short circuits can be located and serviced.
1. Perform New Generation Star Tester Hookup and Vehicle Selection as outlined.
NOTE: The ignition switch must be in RUN position or test will fail.
2. Rotate dial to menu item Diagnostic Data Link and press trigger.
3. Select module to test by rotating dial to highlight module and press trigger.
4. Menu item Diagnostic Test Modes is highlighted. Press trigger.
5. Rotate dial to highlight menu item Wiggle Test. Press trigger, then press start (Button 3).
