Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Fuel Indication Module Connector Part 2 Of 2
Data Link Diagnostics Test
NOTE: The ignition switch must be in RUN position or test will fail. This test is used to verify the proper operation of communication circuit of each
module on the multiplex communication network or diagnostic communication network or diagnostic communication network.
1. Perform New Generation Star Tester Hookup and Vehicle Selection.
2. Rotate dial to menu item "Diagnostic Data Link" and press trigger.
3. If results of Circuit 914 (+) = 0000 and Circuit 915 (-) = 0000, then the Multiplex Communication Network link test passed. If non-zeros returned,
then go to Network Diagnostic Trouble Code (DTC) Index. See: Diagnostic Trouble Code Tests and Associated Procedures/Diagnostic Trouble
Code Charts/Diagnostic Communication Network DTC Index
4. If results of Circuit 70 (LB/W) = 0, then the Diagnostic Communication Network Link Test passed. If non-zeros returned, then go to Network
Diagnostic Trouble Code (DTC) Index. See: Diagnostic Trouble Code Tests and Associated Procedures/Diagnostic Trouble Code
Charts/Diagnostic Communication Network DTC Index
On-Demand Self-Test
NOTE: This test is used to verify operation of module being tested.
1. Perform New Generation Star Tester Hookup and Vehicle Selection.
NOTE: The ignition switch must be in RUN position or test will fail.
2. Rotate dial to menu item Diagnostic Data Link and press trigger.
3. Select module to test by rotating dial to highlight module and press trigger.
4. Menu item Diagnostic Test Modes is highlighted. Press trigger.
5. Rotate dial to highlight menu item On-Demand Self Test. Press trigger, then press start (Button 3).
6. Prepare the vehicle for entry condition as specified for each module press trigger.
Vehicle Set Up
Perform the following vehicle set-up prior to running any New Generation Star tests:
-
Ignition switch in RUN.
-
Vehicle transmission range (TR) position in P (PARK).