Crown Victoria V8-4.6L SOHC VIN 6 (1996)
2. Remove the accelerator cable retainer from the accelerator cable housing inside the vehicle where the accelerator cable housing passes through the
dash panel into the passenger compartment.
3. Disconnect the accelerator cable at the throttle body throttle lever by rotating the throttle lever to the wide open throttle position and slide cable
through slot in cam.
4. Remove the accelerator cable housing to engine mounting bracket retaining screw.
5. Remove the accelerator cable housing to dash panel retaining nuts, wipe module support bracket and housing.
6. Disconnect speed control actuator cable from the throttle body lever cam, if equipped.
7. To install, reverse removal procedure and ensure accelerator cable retainer is pushed into the accelerator housing at least 6.35 mm (1/4 inch). Also
be sure accelerator cable moves freely.