Crown Victoria V8-4.6L SOHC VIN 6 (1996)
appropriate model 1996 Powertrain/Drivetrain Service Manual and the 1996 Powertrain Control/Emissions Diagnosis (PC/ED) On-Board
Diagnostics II (OBD II) Service Manual for detailed diagnostic and repair procedures.
For the DTCs listed in the Title, complete normal diagnostics and repair as required. If no repairs were indicated, proceed to Step 3. If repairs
were required, first proceed to Step 3, then verify the concern was resolved after the PCM has been reprogrammed by rechecking DTCs after
completing a test drive of the vehicle using the following drive cycle:
-
Allow the vehicle to reach normal operating temperature.
-
Accelerate moderately (1/2 to 3/4 throttle) to 97-105 km/h (60-65 mph).
-
Cruise at 97-105 km/h (60-65 mph) for a minimum of 1 minute (must be on a level road or up a slight grade) using steady throttle pressure.
-
Decelerate rapidly to 56-64 km/h (35-40 mph).
-
Cruise at 56-64 km/h (35-40 mph) for 1 minute (must be on a level road) using steady throttle pressure.
-
Repeat 4 times.
If any DTCs return, repair as required.
3.
Check decal to verify vehicle does not have the latest calibration. If it does not, reprogram the PCM with the appropriate calibration per the
Application Chart using the latest level calibration CD-ROM or later.
