Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Ignition Wire Installation
1. Disconnect ignition wire from spark plug by grasping the boot and twisting slightly in both directions to free it.
Removing Ignition Wires At Coil Pack
2. Disconnect the ignition wire from the ignition coil by squeezing the locking tabs and twisting while pulling upward.
3. Remove ignition wire separators from valve cover retaining studs, open ignition wire separators and remove ignition wires.
NOTE: Whenever an ignition wire is removed for any reason from a spark plug or ignition coil or a new ignition wire is installed, coat the entire
interior surface of the boot with silicone dielectric compound, using a small clean tool prior to installation.
CAUTION: Proper installation of ignition wires is critical to vehicle operation. If any ignition wire is improperly installed on spark plug or
ignition coil, both spark plugs connected to that coil may not operate under load.
INSTALLATION
1. Install each ignition wire to the proper terminal on the ignition coils. The terminals on the ignition coils are numbered. Make sure the boots are
fully seated and that both locking tabs are engaged.
2. Route ignition wire through ignition wire separators and close ignition wire separators.
NOTE: Ignition wire spark plug boot must be positioned 90 degrees from crankshaft centerline (outboard and forward) to make sure the boot seal
is fully seated.
4. Connect ignition wire to spark plug.
