Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Seat Belt: Service and Repair
Cleaning and Inspection
Safety Belt Maintenance
Safety belt assemblies should be periodically inspected to ensure that they have not become damaged and that they remain in proper operating
condition, particularly if they have been subjected to severe stress.
WARNING: ALL SAFETY BELT ASSEMBLIES INCLUDING RETRACTORS, BUCKLES, FRONT SEAT BELT BUCKLE SUPPORT
ASSEMBLIES (SLIDE BAR), IF SO EQUIPPED, AND ATTACHING HARDWARE SHOULD BE INSPECTED AFTER ANY
COLLISION. ALL SAFETY BELT ASSEMBLIES SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THAT THE
ASSEMBLIES SHOW NO DAMAGE AND OPERATE PROPERLY. SAFETY BELT ASSEMBLIES NOT IN USE DURING A
COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER DAMAGE OR IMPROPER OPERATION IS NOTED.
Before installing the new safety belt assembly, the safety belt attaching areas must be inspected for damage and distortion. If the attaching points are
damaged and distorted, the sheet metal must be reworked back to its original shape and structural integrity.
Install the new safety belt(s); then perform Functional Test Procedure. See: Testing and Inspection/Component Tests and General Diagnostics
Safety Belt Webbing
Clean belt webbing only with a mild soap solution recommended for cleaning upholstery or carpets. Follow instructions provided with soap.
WARNING: DO NOT BLEACH OR RE-DYE THE WEBBING, AS WEBBING MAY WEAKEN.