Crown Victoria V8-4.6L SOHC VIN 6 (1996)
1.
Locate the build date code on the build label. Use the examples in Figure 4 and the Build Date Code Translator chart to determine the build date.
2.
The affected seat belt retractors were built from 6/01/98 (23 198 R) through 5/21/00 (21700R) and must be replaced.
a.
If you have determined the seat belt must be replaced based on the build date, replace the seat belt retractor following the service procedures
in Section 01-20A or 501-20A of the appropriate workshop manual.
NOTE:
Some of the safety belt retractors received from Ford Customer Service Division for the affected vehicles have been reworked to include a stowage
clip. Retractors with stowage clips are acceptable regardless of date code.
b.
If you have determined the seat belt does not need replacement, reassemble the retractor (if disassembly is required) as follows:
^
Using a length of mechanic's wire, pull the seat belt retractor anchor and webbing through the anchor boot.
^
Install the anchor bolt and rubber washer. Tighten the bolt to 40 Nm (30 lb-ft).
^
Install the anchor bolt cover.
