Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Seat Belt Buckle: Service and Repair
Buckle End - Front Seats
Removal
1. Remove front track end cover.
2. Remove front center safety belt buckle end anchor nuts and washers (on LH side, disconnect safety belt buckle switch wire).
3. Slide the front seat center passenger belts through this slots in front seat and remove from vehicle.
Installation
1. Slide front seat center passenger belts through slots in front seat.
2. Connect safety belt buckle switch wire on LH side and install washers an front seat center safety belt buckle end anchor nuts. Tighten nuts to 60-90
Nm (45-66 lb-ft).
3. Check the restraint system for proper operation and perform Functional Test Procedure.