Crown Victoria V8-4.6L SOHC VIN 6 (1996)
EXCESS STOCK RETURN
Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.
Attachment III - Technical Information
LEFT FRONT SAFETY BELT RETRACTOR
OVERVIEW
This procedure will require the technician to locate and inspect the build label for the front left-hand seat belt retractor. The build label is located at one
of two possible places on the seat belt webbing. Some minor disassembly may be required to access the build label. An affected seat belt retractor will be
identified by the build date. Only a seat belt retractor determined affected by the build date will be replaced. Follow the appropriate procedure in the
workshop manual.
LOCATING BUILD LABEL
NOTE:
The build label is located either on the seat belt webbing above the anchor boot or under the anchor boot.
1.
Locate the build label on the webbing of the front left-hand seat belt retractor as follows:
^
Look for the build label on the webbing directly above the anchor boot. If the build label is located here proceed to Label Inspection. If the label
is not located here proceed to the next bullet point. See Figure 1.
