Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Wheel Speed Sensor: Service and Repair
Toothed Ring
Rear
REMOVAL
1. Remove axle shaft and position on workbench.
2. Using a thin blade cold chisel between sensor ring and axle flange, strike evenly around flange, forcing indicator ring off of sensor ring journal. Do
not use a screwdriver or similar tool. Extreme care must be taken not to scratch or nick wheel bearing and seal journal.
INSTALLATION
1. Prior to installation of new ring, remove any burrs or nicks from journal.
2. Position Indicator Ring Installation Tool T89P-20202-A, or equivalent, on press with pilot ring facing down.
3. Place new indicator ring over installation tool and insert axle shaft through tool.
4. Place Spacer Tool T85T-4616-AH, or equivalent, over hub end of axle shaft.
5. Press axle shaft until it bottoms out on axle flange.
6. Install axle shaft on vehicle.
Removal and Installation
1. Remove wheel and tire assembly.
2. Remove caliper, rotor and hub assemblies.
3. Using a three jaw puller, remove toothed indicator ring from hub.
4. Reverse procedure to install.
