Crown Victoria V8-4.6L SOHC VIN 6 (1996)
5.
Disconnect the wheel speed sensor 2-way connector at all four (4) wheels (Figure 1).
6.
Remove the hardshell from the harness side of the connector and cut off terminal ends.
7.
Solder new terminal ends (# 101028 found in Drawer B-9 of the Thomas and Betts Terminal Repair Kit) at each harness circuit. Refer to TSB
97-24-14 for proper splice and solder procedures. Also apply solder on the new terminal at the wire crimp area to reinforce the connection (Figure
2).
NOTE
TO PURCHASE A TERMINAL REPAIR KIT OR - ORDER SUPPLIES CONTACT:
^
U.S.A. - THOMAS AND BETTS WIRING SYSTEMS AND COMPONENTS: (800) 466-1986 OR (810) 493-1221
^
CANADA - JOBBORN MANUFACTURING
LIMITED: (800) 337-0823
8.
Reinstall the hardshell and reconnect the harness to the sensor.
9.
Test drive to verify the repair.
10.
If the concern is still present, follow the same procedure as outlined in Step 6 to replace all eight (8) sensor circuit terminals at the 28-way
connector to the ABS module (Figure 1).
