Crown Victoria V8-4.6L SOHC VIN 6 (1996)
3. Position floor jack under the front suspension lower arm, and raise jack to support front suspension lower arm.
4. Remove retaining nut from upper ball joint stud to front wheel spindle pinch bolt.
5. Tap pinch bolt to remove from front wheel spindle.
6. With a suitable pry bar, spread slot to allow ball joint stud to release out of front wheel spindle.
7. Remove the front suspension upper arm retaining bolts and remove front suspension upper arm assembly.
Installation
1. Use reference marks from camber and caster cams as initial settings.
2. Position the front suspension upper arm to the frame bracket and install the two retaining bolts and nuts. Tighten to 136-190 N-m (101-140 lb-ft).
3. Connect the upper ball joint stud to the front wheel spindle and install the retaining pinch bolt and nut. Tighten the nut to 87-119 N-m (64-87
lb-ft).
4. Install the wheel and tire.
5. Remove safety stands and lower front of vehicle.
6. Check caster, camber, and toe. Adjust as required.
