Crown Victoria V8-4.6L SOHC VIN 6 (1996)
8.
Use the Spring Selection Chart to select the correct spring three letter code.
9.
Using the three letter code on the driver's side front spring, replace the steel spring with a pan with load rating one level lower. Replace the right
front spring with part with load rating one level higher (swap springs side-to-side).
CAUTION:
DO NOT USE ANY OTHER SPRINGS THAN THOSE SPECIFIED OR MIX SPRING RATES.
10.
Test drive the vehicle for about 3 km (2 miles) over a moderate road surface to settle the suspension before re-evaluating it for body lean. Revent
the air suspension prior to making lean measurements.
NOTE:
BUMPER HEIGHT SHOULD BE BETWEEN 365-416 mm (14.4-16.4") AT THE FRONT AND 370-422 mm (14.6-16.6") AT THE REAR
RESPECTIVELY AFTER CORRECTIVE ACTIONS HAVE BEEN COMPLETED.
11.
It this procedure does not reduce the lean to acceptable levels of 12.7 mm (0.5"), refer to TSB 93-1-1 for the body/frame shimming procedure.
This procedure may be performed to further reduce the vehicle lean condition.
12.
Verify vehicle alignment is within specification after completing repairs.
