Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Throttle Valve Cable/Linkage: Adjustments
Throttle Linkage
THROTTLE LINKAGE ADJUST
NOTE: The 3.8L, 3.8L SC, and 4.6L SEFI engines use an air bypass Idle Speed Control (ISC) that does not affect throttle position. Therefore,
automatic idle setting does not affect TV cable adjustment.
1. Set parking brake, then place shift selector in Neutral position.
NOTE: Do not check or set TV pressure in Park.
2. Remove air cleaner cover and inlet tube from throttle body inlet to access throttle lever and cable assembly.
3. Using a wide blade screwdriver, pry cable assembly out of grommet on throttle body lever.
4. Ensure plastic block slides freely on notched rod.
5. While holding throttle lever firmly against its idle stop, push grooved pin into grommet on throttle lever as far as it will go.
NOTE: While pushing pin into grommet, ensure throttle lever does not move away from idle stop.
6. Ensure grooved pin is fully installed while holding throttle lever firmly against idle stop.
