Crown Victoria V8-4.6L SOHC VIN 6 (1996)
Power Window Motor: Service and Repair
Rear Door Window Motor
Removal
1. Remove rear door trim panel and watershield. See: Body and Frame/Doors, Hood and Trunk/Doors
2. Disconnect battery ground cable. .
3. Disconnect window regulator electric drive wires at multiple connector.
4. NOTE: Use care not to enlarge sheet metal holes in the door inner panel.
Remove three 1/4-inch rivets attaching the window regulator electric drive bracket to inner panel.
5. Working through access hole, remove window regulator electric drive bracket from inner panel and slide window regulator electric drive back to
gain access to three window regulator electric drive retaining screws.
6. Remove window regulator electric drive retaining screws using a Torx® Drive Bit Set D79P-2100-T or equivalent and separate window regulator
electric drive from rear door electric window regulator.
7. Remove window regulator electric drive from rear door.
Installation
1. Position window regulator electric drive to rear door electric window regulator and window regulator electric drive mounting bracket. Install three
window regulator electric drive screws. Tighten to 5-7 N.m (44-62 lb-in).
2. Position window regulator electric drive mounting bracket to inner panel. Install three rivets (1/4-20 x 1/2 inch bolt and 1/4-20 nut and washer
assemblies or equivalent metric fasteners may be used).
3. Connect window regulator electric drive wiring.
4. Connect battery ground cable.
