Crown Victoria V8-4.6L SOHC VIN 6 (1996)
door electric window regulator to inner panel. Use drift punch to knock out center pins for each rivet. Using a 6.35mm (1/4-inch) diameter drill,
drill out remainder of rivet. Use care not to enlarge sheet metal holes in the door inner panel.
6. Remove two upper rear door electric window regulator retaining nuts.
7. Remove rear door electric window regulator.
Installation
1. Lubricate rear door electric window regulator with Teflon® Lubricant E7FZ-19590-A (ESB-M1C111-A) or equivalent.
2. Install rear door electric window regulator into access hole in inner panel.
3. Position rear door electric window regulator using upper rear door electric window regulator studs and tabs on window regulator electric drive
mounting bracket.
4. Install rivets retaining rear door electric window regulator to door inner panel (1/4-20 x 1/2 inch bolt and 1/4-20 nut and washer assemblies or
equivalent metric fasteners may be used as alternates).
5. Install two upper rear door electric window regulator retaining nuts. Tighten to 9-14 N-m (7-10 lb-ft).
6. Install rear door electric window regulator.
7. Adjust rear door window glass.
8. Install watershield and rear door trim panel. See: Body and Frame/Doors, Hood and Trunk/Doors
