Crown Victoria V8-4.6L SOHC VIN W (2005)
Body Control Module: Service and Repair
Air Suspension Module
MODULE - AIR SUSPENSION
Removal and Installation
1. Disconnect the battery ground cable.
2. Remove the pin-type retainers and lower the instrument panel lower insulator.
3. Remove the instrument panel lower insulator.
1
Disconnect the power point electrical connector.
2
Remove the footwell lamp.
4. Remove the air suspension module.
1
Disconnect the electrical connectors.
2
Release the spring clips to remove the module from the bracket.
5. To install, reverse the removal procedure.
-
Check for correct operation.