Crown Victoria V8-4.6L SOHC VIN W (2005)
11.
Install three (3) of the new springs on the right side of the seat first. (Figure 6)
NOTE
THE OPEN END OF THE SPRING SHOULD ALWAYS FACE DOWNWARD SO THAT THEY DO NOT DAMAGE THE SEAT CUSHION
REFER TO FIGURE 6.
12.
Use vise grip pliers or equivalent to install the remaining three (3) springs. (Figure 6)
13.
Place mesh shield on top of the new steel seat cushion support. (Figure 7)
14.
Reinstall seat belt buckle nut and Torque to 30 lb-ft (40 N.m).
15.
Reassemble seat by reversing the disassembly procedure in Steps 3 to 4 and install seat and reactivate the SRS system per the Workshop Manual,
Section 501-10.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
060810A
2005-2006 Crown
1.0 Hr
Victoria/Grand Marquis:
Replace The Drivers Lower
Seat Cushion Support,
Springs Includes Time To
Depower And Repower