Crown Victoria V8-4.6L SOHC VIN W (2005)
7.
Remove the two (2) plastic pin-type retainers, which attach the seat mat to the metal frame and discard. Refer to part "A" on Figure 4.
8.
Using vise grips pliers or equivalent, remove the six (6) woven seat cover retainer clips that attach the woven seat cushion support to the seat
frame and discard the support. Refer to part "B" on Figure 4.
9.
Position the seat in an upright position.
10.
Secure the steel seat cushion support into the four (4) locating holes on the seat frame as shown in Figure 5.
