Crown Victoria V8-4.6L SOHC VIN W (2005)
Seat Track: Service and Repair
SEAT TRACK
Removal and Installation
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
To reduce the risk of personal injury, do not use any memory saver devices.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may
result in damaged components.
NOTE:
-
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
-
The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate
a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Driver side shown, passenger side similar (except where indicated).
All seat tracks
1. Position the seat to access the fasteners.
2. Depower the SRS.
3. Remove the affected seat.
Driver seat track only
4. Disconnect the buckle electrical connector.
5. NOTE: At installation, make sure the safety belt buckle is accessible to the occupant.
Remove the nut and the safety belt buckle.
Passenger seat track only
