Crown Victoria V8-4.6L SOHC VIN W (2005)
Brake Pad: Service and Repair
Rear
Brake Pads
Removal and Installation
1. Remove the wheel and tire assembly.
2. CAUTION: Do not allow the caliper to hang from the brake hose. Damage to the hose can result.
Remove the bolts and lift the caliper off the anchor plate.
3. CAUTION: Do not allow grease, oil, brake fluid or other contaminants to contact the brake pads.
Remove the brake pads by pushing inward and rotating the pad up.
4. NOTE: Use a block of wood or used pad to protect the piston and boots.
Retract the caliper piston into the rear disc brake caliper.
5. To install, reverse the removal procedure.
^
Make sure the slippers are clean and in good condition.
