Crown Victoria V8-4.6L SOHC VIN W (2005)
Electronic Brake Control Module: Service and Repair
Anti-Lock Brake System (ABS) Module
Removal and Installation
1. Remove the air cleaner.
2. Disconnect the battery.
3. NOTE: Clean any foreign debris before removing the ABS module.
Disconnect the ABS module electrical connectors.
^
Disconnect the control module electrical connector.
^
Disconnect the pump motor electrical connector.
4. NOTE: Care must be taken when removing the module from the hydraulic control unit (HCU).
Remove the ABS module.
^
Remove the screws in the sequence shown.
^
Remove the module.
^
To install, tighten to 3 Nm (27 inch lbs.).
5. NOTE: Be sure the ABS module to HCU gasket is clean and correctly installed.
To install, reverse the removal procedure.
