Crown Victoria V8-4.6L SOHC VIN W (2005)
Brake Switch (Cruise Control): Service and Repair
SPEED CONTROL DEACTIVATOR SWITCH
Removal
1. Remove the speed control deactivator switch.
1
Rotate counterclockwise and remove the speed control deactivator switch.
2
Disconnect the electrical connector.
Installation
1. Fully apply the brake pedal.
2. Install the speed control deactivator switch.
1
Position the speed control deactivator switch in the bracket and rotate clockwise.
2
Connect the electrical connector.
3. Insert a 1 mm (0.04 in) feeler gauge between the brake pedal actuation surface and the deactivator switch plunger.
4. Slowly release the brake pedal.
