Crown Victoria V8-4.6L SOHC VIN W (2005)
1. NOTE: The crankshaft pulley must be installed within four minutes after applying the silicone.
Apply sealant to the woodruff key slot on the crankshaft pulley.
2. Use the special tool to install the crankshaft pulley.
3. Install the bolt and washer. Tighten the bolt in four steps.
^
Step 1: Tighten to 90 Nm (66 ft. lbs.).
^
Step 2: Loosen the bolt.
^
Step 3: Tighten to 47-53 Nm (34-39 ft. lbs.).
^
Step 4: Tighten an additional 85-90 degrees.
4. Install the drive belt.
5. Install the engine cooling fan and the fan shroud.