Crown Victoria V8-4.6L SOHC VIN W (2005)
Alignment: Service and Repair
Ride Height Adjustments (Vehicle Dynamic Suspension)
Special Tool(s)
WARNING: Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components
supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal
injury.
CAUTION: The suspension height D dimensions are for reference only. The vehicle attitude must be controlled by the correct dimensions to prevent
vehicle damage.
NOTE: Improper air suspension ride height D dimension can be caused by an air suspension system that is incorrectly set.
1. Position the vehicle on a level surface over an open repair pit.
2. Open the luggage compartment and verify that the air suspension switch is turned on.
3. Turn the ignition switch to the RUN position and wait at least two minutes.
4. Position the special tool on the rear axle.
5. Measure the ride height D dimension.
1
Release the set screw.
2
Pull the sliding post and scale up until it touches the bottom of the inboard frame rail and lock the set screw.
