Crown Victoria V8-4.6L SOHC VIN W (2005)
4. Remove the spring and the actuator
5. Using the special tool, press the wheel stud from its seat.
6. Rotate the flange so that the tip of the wheel stud is pointing upwards and remove the wheel stud.
-
Discard the wheel stud.
Installation
CAUTION: Never use air tools to install wheel studs. The serrations can be stripped from the stud.
1. Insert a new wheel stud in the hole in the axle flange, making sure the serrations are aligned with those made by the original wheel stud.
2. Place four flat washers over the outside end of the wheel stud, and thread a standard wheel nut with the flat side against the washers.
3. Tighten the wheel nut until the wheel stud head seats against the back side of the axle flange.
4. Remove the wheel nut and washers.
